libby, mt



This is a 24'x30'x10' pole building with a 10'x8' bump-out in back to accommodate the owner's boat.



Wainscoting on and concrete poured.



Sideview of the building.



Rear view with the bump-out.



Beverly drive, sagle



40'x40'x16' pole building with a 14'x40' lean-to.





Trusses set, roof metal is on, and side metal is going up. Will close up the front after grading rock has been done.





High windows set.







Power-troweled finish on the concrete.





Sidewalls are up, and roof trims completed.





Finished building waiting for overhead doors.





noxon, mt



This house was in serious need of a new roof! There was water damage on the outside edges of the roof on the right that needed replaced.



1x4 stripping is going on top of the old shingles, keeping some water integrity for the project.



Applying green metal and trims to the 1x4 stripping.



Much better - and water tight!



selle valley, sandpoint id



The owner had put up the main structure, but needed lean-to's built on both sides of the building, and then the whole thing covered with metal.



Rafters just fitting under the existing eaves for the most headroom available, and crushed rock applied, ready for concrete.



Wall metal up, getting ready for trims.



Finished building, waiting for the new overhead doors to be installed.



Troy, mt



This is the foundation for a log home above Kilbrennan Lake. Owner ended up blasting out the hole, as it was mostly granite.



Footings are all formed, and getting ready to pump them with concrete.



Footings are all formed, and getting ready to pump them with concrete.



Once the footings were done and stripped, now the 4'-high walls are going up.



Forms stripped, and ready for a house!



rapid lightning rd sandpoint



This is a 30'x40'x14' pole building with a 8'x20' lean-to off the side for a porch, and (2) 10'x12' overhead doors.



This building was a package bought at the local lumberyard, so the construction is different that our usual method of setting trusses on 2'-centers. This building has trusses attached to each side of the poles with rafters strung between them.



The building is framed and ready for metal.



The porch/lean-to has been attached to the building.



The inside concrete has been poured and power-troweled finished, and the porch area has a broom-finish.



Finished building.



crestview ln sagle, id



This site presented the challenge of being on a hill side. We were able to level about half of it, but the downhill side needed more work, with extra posts to hold the extra material that we will need for a concrete pad.



The retaining wall is being built of treated lumber.



The building is framed, roof on, and ready for rock.



Roofline and soffits.



Starting the process of adding rock to the lower part of the building, which will be tamped with water in 2" slumps to prevent voids and possible concrete cracks.



There were many loads of rock brought in to fill the lower part, which were tamped in 2" slumps with water, to prevent any voids and possible cracking in the slab.



Adding sidewall metal, with wainscoting.



Windows and doors installed, and sidewalls completed.



Windows and doors installed, and sidewalls completed.



Vortex Way, Sagle



This is one of the prettiest worksites we have worked at, with an incredible view. However, because of the slopes, the foundation of this monopour presented a unique challenge. This will be a 25'x40'x19', 2-story conventional-framed shop with a 10'x8' overhead door, and six windows.



The monopour was excavated, and will need to be backfilled at some point. The evening was forecast rain, so the slab was covered to protect it after power-troweling.



This building is two stories with conventional 2x6 framing, with staircase. Here, the 2nd-floor decking has been installed and the walls are going up.



Both stories are framed, and horizontal stripping is being installed for the metal to be attached to.



Here is the building with trusses installed and roof sheeted.



The owner provided the cupola - the finishing touch for this building!



Metal sidewalls and trims installed. Waiting for corners.



Finished building, with doors, windows, and trim installed. Sidewalls on this side were over 20' in the air from this low side.



Ready to move in!



Buck ridge, sagle



30'x30'x12' pole building with (1) 10'x10' overhead door.



Some trees needed taken out before starting, and excavation done to keep water away from the building. The building is almost done and concrete poured.



Finished building, ready for the overhead door.



Main street, bonners ferry



This is a 32'x32' pole building with a 10'x32' lean-to and continuous roof. The building has concrete under the lean-to.



Main bullding is framed, and ready for the lean-to.



The lean-to is on, and concrete poured in the main building and lean-to.



Metal is on, and owners have started moving in!



Metal is on, and owners have started moving in!



Inside view, with trusses 2'-on-center, corner bracing, and outside nailers on 2'-centers.



jeru ridge, Sandpoint



Lorem ipsum dolor sit amet, consectetur adipiscing elit. Sed malesuada faucibus ex nec ultricies. Donec mattis egestas



A place for a title



Lorem ipsum dolor sit amet, consectetur adipiscing elit. Sed malesuada faucibus ex nec ultricies.



J&M Construction Services